MERCRUISER: serial numbers between 2062141 and OD469858 inclusive, requires an Alpha I system. This unit requires the Volvo-SX/Cobra bracket. In 1994 Volvo and OMC joined forces to make a drive unit. For drive units produced after 1984, the cobra bracket will be required. OMC: Pre-1984 OMC units will take the OMC bracket. If this does not correct the problem then please call us.ĭifferent outdrives require different brackets. If the rod hits the swim platform, point the auxiliary bracket quick connect down. The quick connector must point down to give proper clearance under the platform. Swim platform models take a special bracket and longer rod. Raise both motors without disconnecting rod even with a full (or 3/4) swim platform. If further adjustments are necessary, turn the Allen screw by one-eighth of a turn increments. Check the scale reading to see how much pressure was needed to compress the rod. If you want to check the accuracy of this adjustment, you can extend the rod, place the end of the rod on a bathroom scale, and try to compress the rod. This will adjust the rod so that approximately 20 pounds of pressure is needed to make it adjust. Now back off the Allen screw one and one-half turns. At this point, tighten the Allen screw until it is snug. As soon as the inner rod is movable, extend or insert the inner rod until you feel the detente pin drop into one of the grooves in the inner rod. If the inner rod will not move, remove the white plastic cap on the outer rod and back off the Allen screw inside the detente tube. Move the inner rod in or out of the outer rod. (Either the auxiliary will not follow because the rod slips, or with the auxiliary motor tipped up the rod does not extend.) Rod does not adjust properly, it is either too loose or too tight. The rod is preset to approximately 20# of pressure and shouldĭo not oil or grease the rod, as it will gum up the détentes and The end should now be held securely in place. The rod to the main unit bracket, pushing the quick connector’s moveable collar down, inserting the end of the ball joint into the quick connector, and releasing the collar. Extend or contract the rod to the approximate length. To assemble, simply insert the inner grooved tube into the outer smooth tube with a twisting motion. The steering rod consists of two stainless steel tubes. The EZ-Steer ties your kicker motor to your main motor ,Īllowing you to steer your auxiliary motor from the helm. These connector kits let you troll using your regular steering wheel for control. Link your main engine to your auxiliary trolling motor, Not available for Mercury 4 stroke until 2023
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |